Iron-On Transfers for Polo Shirts
An iron-on transfer for polo shirts is a heat-applied printed design used to add company logos, staff names, or branding to cotton and polyester workwear polos without embroidery. DTF Owl prints your uploaded design as a ready-to-press polo shirt transfer in full colour - no setup fees, no minimum order, and no multi-week wait. From £1.99 per transfer, with results that last 50+ washes.
Why DTF Transfers for Workwear Polos?
Small and medium businesses often need branded polo shirts but cannot justify the minimum orders and setup fees that embroidery companies require. A new starter joins the team and you need one branded polo - not 25. A client-facing event needs six polos by Friday - not in three weeks.
DTF transfers solve both problems. Order a single transfer for£1.99, apply it to a blank polo shirt you already own (or buy a blank from any workwear supplier), and you have a branded polo in minutes. When the next new starter joins, order another one. No minimum quantities, no dead stock, no wasted budget.
Application Guide for Polo Shirts
| Polo fabric | Temperature | Press time | Notes |
|---|---|---|---|
| Polyester pique | 150°C | 10 seconds | Most common workwear polo. Do not exceed 160°C. |
| Cotton pique | 150-160°C | 12-15 seconds | Premium feel. Slightly longer press for best adhesion. |
| Cotton/poly blend | 150°C | 10-12 seconds | Common in mid-range polos. Good adhesion. |
Place a pressing board or folded towel inside the polo to create a flat pressing surface. Fold the collar and button placket out of the way before pressing chest logos.
Polo Shirt Transfer FAQs
Can you iron transfers onto polo shirts?
Yes. Our DTF transfers bond to both cotton and polyester polo shirts. For polyester polos (the most common workwear type), use 150°C and avoid exceeding 160°C. For cotton pique polos, 150-160°C works well. The textured pique weave common on polo shirts gives good adhesion.
Where should I position a logo on a polo shirt?
The standard position for a company logo is the left chest, roughly 8-10cm from the centre and 8-10cm below the collar seam. Logos in this position are typically 6-10cm wide. Back logos are usually centred between the shoulder blades at 20-30cm wide. Sleeve prints (upper arm) work at 5-8cm wide.
How do I press around the polo shirt collar and buttons?
For chest logos, position the transfer below the button placket. You do not need to press over the buttons. If the design overlaps the placket area, unbutton the shirt, fold the placket aside, and press the design onto the flat fabric behind it. For the collar area, fold the collar up out of the way before pressing.
Can I add different staff names to each polo?
Yes. Every transfer can be different - each one is printed individually from your uploaded design. Upload a different name for each shirt, or use our gang sheet tool to print multiple names on one sheet and cut them apart.
Is this cheaper than embroidered polo shirts?
For small quantities, significantly cheaper. Embroidered polo shirts typically have a minimum order of 10-25 pieces and cost £15-30 each (garment plus embroidery). With DTF transfers, you buy blank polos (£5-10 each from workwear suppliers) and add transfers from £1.99 each. You can also add logos to polos you already own.
Transfers by Garment
Ready to Brand Your Polo Shirts?
Upload your logo and get custom polo shirt transfers delivered to your door. No minimum order. No embroidery setup fees.
Start Your Order